I have add the gcode, 3mf files and a photo of the finished model, I hope to find out why this is happening please. The other issue is the temperature settings are changed at line 30844 After laying the first layer there was a 2-3 second pause over the part first layer then moved to the prime tower and swiched to extruder 1 then moved to the part and switched to extruder 2, this proccess continues.Įxtruder 1 has no reason to do any thin till 1.5mm The print adheasion is set for extruder 2 and the first part is with exruder 2. I have the same issue in 2023, I have Geeetech A10M which has 2 extruders in 1 hot end out. Hi I can see that this has been an issue since these post in 2020. What would be good with the dual extruder is to seperate hotend and extruder so you would have Dual Extruder and Dual Hotend. When a removable drive is connected the button changes to Save to Removeable Drive but when clicked it just saves the file regardless if it exists and if it does exist it is not overwritten The other issue I have is saving the gcode, after slicing the model the button changes to Save to Disc which opens a window so the file can be saved thats fine. When the model is imported it is in the correct Z position but then is reset to Drop Down Model even though I set Lock Model. What I did notice with the Move setting is that it dose not keep the Z position once Cura has fully loaded. The models used in this are a disc (yellow) and a number, the number (red) is to be printed on the disc. I when back to my 3mf file to see if there were any settings for dual extrusion that may change the behavor when priming but there is no extruder specific setting in Dual Extruder settings. Click File > Open Profile to navigate to the printer profile “NWA3DĪ5 Printer Profile.ini” that came on the microSD card in the Cura folder.I posted this a on another topic ( Strange purging behavior with a prime tower) earler this morrning but it was old and no resolution. ![]() Quality settings that will automatically reset all the values to ones that will If your slice settings are really messed up, try re-loading the Printer ![]() Will help the part stick so it doesn’t curl up at the edges.) ![]() May need to select “Brim” Adhesion support type and reslice the file. That the model will print on.) If the part warps when you begin to build it, you (A raft is a hatch pattern on the build plate If it’s intricate, it may need to select “Raft”įor the Platform adhesion type. You may need toĪdjust this value to your liking for your model. Check the Fill Density (infill) and make sure it is at least 5%. Window (the NWA3D A5 does not have a heated bed).į. Make sure the Heated bed checkbox is unchecked in the Machine settings Make sure the filament diameter is 1.75mm and the flow rate is 100%.Į. For PLA, they should be set to 30–50mm/sĭ. (high-quality prints) and 0.3mm (low-quality prints).Ĭ. Make sure that the layer height is between 0.1mm Making good contact with the build surface, and isn’t too big for the buildī. Make sure the print is centered in the build area, Here are some steps to make sure your Cura settings are correct.Ī. ![]() Sometimes, models don’t print correctly because the settings in the G-Code are Cura 15.04.6 Slicer settings Cura Download: Ultimaker Cura All Versions NWA3D A5 Video Tutorial:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |